VENTS Quiet 125 Duo V

• Innovative exhaust fan with stylish design.
• Ideal for intermittent or continuous ventilation of bathroom, showers, kitchens and other utility spaces.
• Two-speed ventilation up to 170 m³/h.

• Permanent low-speed operation mode ensures continuous minimum air exchange in the room.
• Mounting into ventilation shafts or connection to Ø 100 mm and 125 mm air ducts.

• The casing and the impeller are made of high-quality and durable UV-resistant plastic.
• The specially designed aerodynamic profile of the mixed-flow impeller provides high air capacity combined with low-noise operation.
• The compact design enables wall and ceiling installation.
• A shortened spigot for mounting into a ventilation shaft or direct connection to Ø 100 mm and 125 mm air duct.

• The fan is equipped with a specially designed back valve to prevent back flow and heat losses during the fan standby.
• The fan exhaust spigot incorporates specially designed air rectifiers to reduce air turbulance, noise level and boost air pressure.
• High ingress protection rating makes the fan the ideal solution for bathroom ventilation. The electronic components are protected with tight covers.

• Low energy demand from 4 W due to a new two-speed high-efficient motor.
• Maintenance-free bearings contain enough grease for 40 000 hrs non-stop operation.

• Motor on special anti-vibration dampers for vibration absorbing and silent operation.
• Motor equipped with overheating protection.

The fan operates at the low speed by default. The fan switches to the high speed when the switch is closed or the humidity sensor is activated.

Manual control:

• Manual control with a room light switch. The switch is not included in the delivery set.
• The fan is controlled by the built-in pull cord switch V. Not applied in case of ceiling mounting.
• Speed control with the thyristor speed controller or speed switch P2-1-300, see Electrical Accessories. Several fans may be connected to the same controller. Speed controllers are not compatible with the fans with T, TH modification. .

Automatic control:

• By the electronic control unit BU-1-60 (see Electrical Accessories). The control unit is supplied separately.
• By the timer T. The built-in run-out timer enables the fan operation at the high speed within 2 to 30 minutes after the fan switching off.
• By the humidity sensor and timer TH. If the humidity level in the room exceeds the sensor threshold within 60-90% the fan switches automatically to the high speed and operates until the humidity level drops to the standard level. After that the fan continues operating within the set time period and then reverts to the standard operation mode with the low speed.

• Installation directly inside a ventilation shaft.
• Flexible air ducts may be used in case of remote location of the ventilation shaft. The air duct is connected to the exhaust spigot with a fixing clamp.

• Wall mounting with screws.