VENTS 125 Simple

• Continuous or periodic exhaust ventilation of bathroom, showers, kitchens and other utility spaces.
• Ventilation shaft mounting or duct connection.

• Low to medium air flow motion for short distances at low air resistance.
• Compatible with Ø 100, 120, 125 and 150 mm air ducts.

• Modern design and aesthetic look.
• The casing and the impeller are made of high-quality durable ABS plastic, UV resistant.
• The intellectual impeller design makes the fan efficiency high and the service life long.

• Insect screen.
• Protection rating IP34.

• Reliable and low-watt electric motor.
• Designed for continuous operation and requires no maintenance.

• Equipped with overheating protection.

Manual:

• The fan is controlled by a room light switch. It is not included in the delivery set.
• The fan is controlled by the built-in V pull cord switch. Not applied in case of ceiling mounting.
• Speed control is possible through a thyristor speed controller (see Electrical Accessories). Several fans may be connected to the same controller. Speed controllers can not be connected to the fans with the T, TH, TP, VT, VTH modifications.

Automatic:

• By the BU-1-60 electronic control unit. The control unit is supplied separately.
• By the T timer (the built-in turn-off delay timer enables the fan operation within 2 to 30 minutes after the fan switching off).
• By the humidity sensor and the TH timer (if the humidity level in the room exceeds the sensor threshold adjustable value within 60-90 %, the fan switches automatically on and operates until the humidity level drops to the standard level, after that the fan continues operating within the time period according to the timer setting, then shuts down).

• The fan is mounted directly into the ventilation shaft.
• In case of remote location of the ventilation shaft flexible air ducts may be used. The air duct is connected to the fan exhaust flange through a clamp.

• Fixed to the wall by means of screws.
• Can be ceiling mounted in case the fan is ordered with ball bearings (Simple L modification).