VENTS 100 Flip (230/60)

• Permanent or intermittent extract ventilation of shower rooms, bathrooms, kitchens and other residential premises.
• Ventilation of premises with high requirements to noise level.

• Mounting into ventilation shafts or connection to Ø 100 mm air ducts.

• Modern design and aesthetic look.
• The casing, the impeller and the front panel are made of high-quality and durable UV-resistant plastic.
• The specially designed aerodynamic profile of the mixed-flow impeller provides high air capacity and pressure combined with low-noise operation.

• The fan is equipped with a specially designed backdraft damper to prevent back flow and heat losses during the fan standby.
• The fan exhaust spigot incorporates specially designed air rectifiers to reduce air turbulence, noise level and boost air pressure.

• Reliable motor with low energy demand.
• Rated for continuous operation and is completely maintenance-free.

• Integrated overheating protection.

Automatic control:

• Control with the electronic control unit BU-1-60. The control unit is supplied separately.
• Control with the turn-off delay timer T. The built-in turn-off delay timer enables operation of the fan within 2 up to 30 minutes after turning the fan off with a switch.
• Control with the timer T1. After turning of the external switch the turn-on delay timer is activated for 10 seconds up to 2 minutes. The fan remains turned off. After the fan is turned off with the external switch the fan keeps running within 2 up to 30 minutes according to the settings of the turn-off delay timer.
• Control with the timer and humidity sensor TH. If the indoor humidity exceeds the set humidity point adjustable from 60% to 90%, the fan switches automatically on and runs until the indoor humidity drops below the set humidity point. After that the fan continues running according to the timer settings and turns off.

Manual control:

• Manual operation with a room light switch (not included in the delivery set).
• Operation with a built-in pull cord switch V. Not applicable in case of the ceiling mounting.

• Direct installation inside a ventilation shaft.
• Flexible air ducts may be used in case of remote location of the ventilation shaft. The air duct is connected to the exhaust spigot with a fixing clamp.

• Wall mounting with screws.
• Suitable for ceiling mounting.